Menu
Your Cart
Our order fulfillment operations will remain suspended on 29th and 30th March 2024 for FY Closing. Any order placed after 2 PM on 28th March will be shipped on 1st April 2024. 

TP4056 Li-ion Battery Charger Module with Protection - Micro USB

TP4056 Li-ion Battery Charger Module with Protection - Micro USB
Generic
TP4056 Li-ion Battery Charger Module with Protection - Micro USB
₹​19.00
₹​16.10 + 18% GST
All Inclusive, Shipping Calculated at Checkout

B2B GST Credit Available
100 or more ₹​18.59
1000 or more ₹​17.70

TP4056 Li-ion Battery Charger Module with Protection 

This module is made for charging rechargeable lithium batteries using the constant-current/constant-voltage (CC/CV) charging method. In addition to safely charging a lithium battery the module also provides necessary protection required by lithium batteries. See below concerning the protection features this module provides.



Protection Features

This module uses the TP4056 Li-Ion charge controller IC and a separate protection IC. There are other types of modules on the market that use the TP4056 but lack any protection circuits or ICs to provide the necessary protection needed with lithium batteries. This module uses both the TP4056 and the DW01A Li-Ion battery protection IC, which together in combination provide the following protection features:

  • Manage the constant current to constant voltage charging of a connected lithium battery
  • Over-discharge protection - keeps your battery from being discharged below 2.4V, a healthy minimum voltage level for your battery If a connected  battery has been discharged below 2.4V the module will cut output power from the battery until the battery voltage has been re-charged above 3.0V (the over-discharge release voltage), which at that time the module will again allow discharge of power from the battery to a connected load. Although the module cuts output power from the battery during an over-discharge situation, it still allows charging of the battery to occur through the parasitic diode of the discharge control MOSFET (FS8205A Dual MOSFET).
  • Overcharge protection - the module will safely charge your battery to 4.2V
  • Overcurrent and short-circuit protection - the module will cut the output from the battery if the discharge rate exceeds 3A or if a short-circuit condition occurs
  • Soft-start protection limits inrush current
  • Trickle charge (battery reconditioning) - if the voltage level of the connected battery is less than 2.9V, the module will use a trickle charge current of 130mA until the battery voltage reaches 2.9V, at which point the charge current will be linearly increased to the configured charge current.

Write a review

Note: HTML is not translated!
Bad Good
Captcha