ST Link V2 Programmer For STM8 and STM32

ST Link V2 Programmer For STM8 and STM32

ST LINK V2 is an in-circuit debugger and programmer for the STM8 and STM32 Microcontroller | single wire interface module (SWIM) | JTAG/serial wire debugging (SWD) interfaces | ST-LINK V2 supports full range of debugging, using a simple 4-wire interface (including power). | ST-LINK V2 comes in a very solid and high quality anodized aluminum shell.

USB In-Circuit Programmer and Debugger compatible with ST-LINK V2 for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) is used to communicate with any STM8 or STM32 microcontroller located on an application board. It supports SWIM download debugging. The supported software versions are for example: - ST-LINK Utility 2.0 and above - STVD 2 and above - STVP 3.2.3 and above - IAR EWARM V6.20 and above - IAR EWSTM8 V1.30 and above - KEIL RVMDK V4.21 and above The ST-LINK V2 compatible USB adapter supports an automatic firmware upgrade, to ensure compatibility with future STM controllers.

Features

• PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
• Interface definition directly marked on the shell, clear, convenient and practical!
• 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
• Shell characters using laser engraving, never fade off! Permanent clarity!
• 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
• Red and blue color LED indicator, allowing you to always observe ST-LINK V2 working condition!
• With 4 DuPont line, so you can easily respond to different target board line order!
• Use anti-static bag packaging.

Specifications

• Support the full range of STM32 SWD debugging interface, a simple 4-wire interface (including power), fast, stable; Pin connections labeled on case! You Do not have to read the manual every time to make connections
• Support the full range of STM8 SWIM download debugging (common development environments such as IAR, STVD etc. are supported)
• Support for automatic firmware upgrades to ensure follow-up support ST products. The factory firmware has been upgraded to the latest 
• Increase the 5V power output, the output I / O ports are protected so neet does not worry about operational errors caused by ST-LINK V2 damage!
• The use of U disk aluminum housing protects the motherboard, is easy to carry, is not without worrying about static electricity, handling, etc.

Supports For ST-LINK V2 

• ST-LINK Utility 2.0 and above.
• STVD 4.2.1 and above.
• STVP 3.2.3 and above.
• IAR EWARM V6.20 and above.
• IAR EWSTM8 V1.30 and above.
• KEIL RVMDK V4.21 and above.