B2B GST Credit Available
- Stock: 2 in Stock
- SKU: 6799
- Delivery Time
- Bulk & B2B RFQ
CC Debugger - Debugger and Programmer for RF System-on-Chips
The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.
Package Content
- CC Debugger x 1
- USB Cable x1
- 10 P FRC Cable x 1
Performance
- Compatible with the original TI CC Debugger
- Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
- Target voltage: 1.2V～3.6V
- Capable of powering the target board from the debugger
- Operating temperature: 0℃～85℃
Supported Software
- IAR Embedded Workbench For C8051
- SmartRF Flash Programmer
- SmartRF Studio
- SmartRF Packet Sniffer
- PurePath Wireless Configurator
- Connects to PC
- Computer connection via USB interface
- Connects to target board
- Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:
- Target board connection via 10-pin IDC connector (2x5 2.54mm pitch). The figure below shows the header pinout:
Programming and debugging the following 8051-based system-on-chips from Texas Instruments:
CC1110, CC1111, CC2430, CC2431, CC2510, CC2511, CC2530, CC2531, CC2533, CC2540, CC2541, CC2543, CC2544, CC2545
Controlling the following transceivers from SmartRF Studio:
CC1120, CC1121, CC1125, CC1175, CC1101, CC110L, CC113L, CC115L, CC2520
Configuring the CC85xx devices with PurePath Wireless Configurator:
CC8520, CC8521, CC8530, CC8531
LED Status
- OFF: The debugger has no power or there is no valid firmware on the debugger.
- AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
- RED LED BLINKING: The Debugger is in Boot Recovery Mode.
- RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
- GREEN LED ON:The target device has been properly detected. It is possible to start programming/debugging.
Development resources: user manual, schematic, firmware, software, etc.
Wiki: www.waveshare.com/wiki/CC_Debugger
