Adapter Board for Arduino & Raspberry Pi

Adapter Board for Arduino & Raspberry Pi

Arduino is a massive ecosystem, if there's a way for the Raspberry Pi GPIO interface to adapt to Arduino pinouts, it is possible to use the Pi together with vast Arduino shields and hardware/software resources. The ARPI600 is just intended for this.

What's more, the ARPI600 also support XBee modules, make it easy to add wireless feature to your great project.

User Manual / Datasheet / Example Codes Etc.

Features

• Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
• Compatible with Arduino UNO, Leonardo, easy to connect with various Arduino shields
• XBee connector for connecting various XBee modules
• Sensor interface for connecting various sensors
• Onboard USB TO UART for serial port debugging, also can be configured as XBee USB adapter
• Onboard ADC, 10 bit, 38KSPS, 11 channels (6 channels for Arduino interface, 5 channels for sensors)
• Onboard RTC

What's on Board

1.Arduino connector : for connecting Arduino shields

2.ICSP interface : Arduino ICSP

3.XBee connector : for connecting XBee communication modules

4.Sensor interface : for connecting sensors

5.Raspberry Pi connector : for connecting Raspberry Pi

6.USB TO UART

7.TLC1543 : AD converter

8.PCF8563 : RTC

9.CP2102

10. 32.768KHz crystal : for RTC

11.Power indicator

12.XBee state LED

13.and Arduino interface RESET button

14.XBee EASYLINK button

15.RTC battery holder : for CR1220 button battery

16.TLC1543 reference voltage configuration jumper

17.RTC jumper

18.UART jumper

• when connecting P_RX and CP_TX, P_TX and CP_RX respectively, USB TO UART is connected to Raspberry Pi serial port
• when connecting XB_RX and CP_TX, XB_TX and CP_RX respectively, USB TO UART is connected to XBee serial port
• when connecting XB_RX and P_TX, XB_TX and P_RX respectively, Raspberry Pi serial port is connected to XBee serial port

19.Arduino AD selection jumper

• short 2 and 3 : Arduino A0-A5 as AD input
• short 1 and 2 : Arduino A0-A5 as digital control

20.Arduino I2C selection jumper

• short the jumper : Arduino A4-A5 as I2C control (the A4-A5 of Arduino AD selection jumper should be opened)

21.Arduino SPI selection jumper

• short 1 and 2 : Arduino D11-D13 as SPI control (default)
• short 2 and 3 : Arduino D11-D13 as digital control

Dimensions