Menu
Your Cart

ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32

ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
ST Microelectronics
ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32
₹​8,573.00
₹​7,265.25 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 73
B2B GST Credit Available
Price in reward points: 7265

ST-LINK/V2-ISOL - ST-LINK/V2 in-circuit Debugger, Programmer for STM8 and STM32

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers. The single-wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to providing the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms.


Datasheet


Features

  • 5 V power supplied by a USB connector
  • USB 2.0 full-speed compatible interface
  • USB Type-A to Mini-B cable provided
  • SWIM specific features:

- 1.65 V to 5.5 V application voltage support on the SWIM interface

- SWIM low-speed and high-speed modes support

- SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed

- SWIM cable for connection to an application with an ERNI standard connector Vertical connector reference: 284697 or 214017 Horizontal connector reference: 214012

- SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector

  • JTAG/serial wire debug (SWD) specific features:

- 1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs

- JTAG cable for connection to a standard JTAG 20-pin 2.54 mm pitch connector

- JTAG support

- SWD and serial wire viewer (SWV) communication support

  • Direct firmware update support (DFU)
  • Status LED blinking during the communication with the PC
  • Operating temperature from 0 °C to 50 °C
  • 1000 Vrms high isolation voltage (ST-LINK/V2-ISOL only)


Package Includes

  • 1x ST-LINK/V2-ISOL 

Write a review

Note: HTML is not translated!
Bad Good
Captcha