Menu
Your Cart

STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32

STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
ST Microelectronics
STLINK-V3MINIE in-Circuit Debugger and Programmer For STM32
₹​1,589.00
₹​1,346.61 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 12
B2B GST Credit Available
Price in reward points: 1230

STLINK-V3MINIE is a stand-alone debugging and programming tiny probe for STM32 microcontrollers. The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board.

STLINK-V3MINIE also provides a Virtual COM port interface for the host PC to communicate with the target microcontroller through one UART. STLINK-V3MINIE is a portable version easy‑to‑use debugger and programmer including STDC14 interface with its flat cable and on‑board pads for board‑to‑board (BTB) card edge connector.


Datasheet


Features

    • Tiny 15 mm × 42 mm stand-alone debugging and programming probe for STM32 microcontrollers
    • Self-powered through a USB Type-C connector
    • USB 2.0 high-speed interface
    • Probe firmware is updatable through USB
    • Support drag-and-drop Flash programming of binary files
    • Two color LEDs: communication, power
    • JTAG communication support up to 21 MHz
    • SWD (Serial Wire Debug) and SWV (Serial Wire Viewer) communication support up to 24 MHz
    • Virtual COM port (VCP) up to 15 Mbps
    • 1.65 to 3.60 V application voltage support

Software Support


What's On-Board?



Write a review

Note: HTML is not translated!
Bad Good
Captcha