Menu
Your Cart

Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included

Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
WaveShare Electronics
Binocular Camera Base Board Designed for Raspberry Pi Compute Module 4, Expander Included
₹​6,161.96
₹​5,222.00 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 52
B2B GST Credit Available
Price in reward points: 5222

This is a binocular camera-based board that is designed for Raspberry Pi Compute Module 4. Two IMX219 800MP cameras are integrated for the stereo vision projects. An interface expander board is optional for connecting other accessories.


Specifications

DUAL CAMERA BASE SPECIFICATIONS
CM4 socketsuitable for all variants of Compute Module 4
NetworkingGigabit Ethernet RJ45
USBUSB 2.0 × 1
FFC connectorHDMI & PCIe & USB FFC connector × 1
GPIO FFC connector × 1
Dual camerapixels8MP
sensorIMX219
resolution3280 × 2464 (per channel)
CMOS size1/4 inch
apertureF2.4
focal length2.6mm
FOV83/73/50 degree (diagonal/horizontal/vertical)
distortion< 1%
baseline length60mm
VideoHDMI × 1, supports 4K 30fps output
StorageMicroSD card socket for Compute Module 4 Lite (without eMMC) variants
Power input5V/2.5A
Dimensions85.0 × 51.5mm


Resources

User Manual


Onboard Peripherals


  1. CM4 socket
    suitable for all variants of Compute Module 4
  2. HDMI connector
    supports 4K 30fps output
  3. USB 2.0 port
    for connecting sorts of USB devices
  4. PWR & USB
    USB-C connector, 5V DC power supply or USB programming port
  5. BOOT selection
    ON: CM4 will be booted from USB-C interface
    OFF: CM4 will be booted from eMMC or Micro SD card
  1. CM4 status indicator
    PWR: Raspberry Pi power indicator
    ACT: Raspberry Pi operating status indicator
  2. RJ45 Gigabit Ethernet
    10/100/1000M compatible
  3. Micro SD card slot
    for connecting a Micro SD card with pre-burnt image (Lite variant ONLY)
  4. GPIO FFC connector
    for expanding 40PIN GPIO
  5. HDMI & PCIe & USB FFC connector
    for expanding HDMI1, PCIe, USB
  6. Dual cameras
    IMX219, 8MP

Write a review

Note: HTML is not translated!
Bad Good
Captcha