Menu
Your Cart

Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4

Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
WaveShare Electronics
Mini Dual Gigabit Ethernet Base Board Designed for Raspberry Pi Compute Module 4
₹​2,622.00
₹​2,222.03 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 22
B2B GST Credit Available

CM4-DUAL-ETH-MINI, a baseboard that can be used with Raspberry Pi Compute Module 4, supports 5V DC Type-C interface power supply, and features dual Gigabit Ethernet ports, single-channel USB2.0 with a fan interface and standard Raspberry Pi 40Pin interface, which is suitable for scenarios requiring multiple network ports such as soft routing.



Resources

User Guide


Specifications

CM4 SOCKETsuitable for all variants of Compute Module 4
NETWORKINGDual Gigabit Ethernet RJ45 connector
USBUSB 2.0 Port
PIN HEADERRaspberry Pi 40PIN GPIO header
STORAGETF card socket for Compute Module 4 Lite (without eMMC) variants
FAN HEADER4-wire SH1.0 port, allows speed adjustment and measurement, 5V
POWER INPUT5V, Type-C interface
DIMENSIONS55.0 × 68.0mm


Interface


Onboard Peripherals


  1. 40PIN GPIO header
    for connecting sorts of HAT
  2. CM4 Socket
    suitable for all variants of Compute Module 4
  3. RJ45 Dual Gigabit Ethernet Port
    Dual RJ45 Gigabit Ethernet ports, 10/100/1000M compatible
    ETHERNET 0: CM4 original network port
    ETHERNET 1: PCIe extended network port
  4. USB 2.0 Type A port
    for connecting sorts of USB devices
  5. FAN header
    for connecting cooling fan, allows speed adjustment and measurement
  6. Reset button
  7. Boot switch
    ON: CM4 would be booted from USB-C interface
    OFF: CM4 would be booted from eMMC or TF card
  1. Type-C port
    5V/2.5A power supply, or used for eMMC programming
  2. TF card slot
    for connecting a TF card with pre-burnt image (Lite variant ONLY)
  3. RTL8111H
    Gigabit NIC chip
  4. Indicator
    PWR: indicating the power supply status of Raspberry Pi
    SYS: indicating the working status of Raspberry Pi
  5. SYSTEM switch
    EEPROM_WP: Prevent EEPROM from being overwritten
    WiFi_DIS: WiFi disabled, only for CM4 version with wireless
    BT_DIS: Bluetooth disabled, only for CM4 version with wireless

Write a review

Note: HTML is not translated!
Bad Good
Captcha