Generic
₹499.00 + 18% GST
B2B GST Credit Available
ENC28J60 Ethernet Module - SPI Interface
1 Pin - Male to Female Jumper Wire - 12 Inch/30.5cm - Pack of 100 PCS Description : These wires are commonly used for prototy..
₹454.30
Ex Gst ₹385.00
1 Pin Female to Female Jumper Wire - 12 Inch - Mixed ColorDescription : These wires are commonly used for prototyping. This&n..
₹9.44
Ex Gst ₹8.00
F-F Jumper Wire - Set of 40 - 2.54mm - 20cm LengthSet of 40 jumper wires with female connector at both ends. Allow you to easily prototype with ..
₹57.82
Ex Gst ₹49.00
F-M Jumper Wire - 20cm Length - 2.54mm - Set of 40Set of 40 jumper wires with female connector at one end and male connector on other. Allo..
₹57.82
Ex Gst ₹49.00
Male to Male Jumper Wires - 1 Pin - Set of 65 Wires - Mix colors - Mix LengthThis is a set of 65 pcs male-to-male high-quality jumper wires cables..
₹93.22
Ex Gst ₹79.00
Male to Male Jumper Wires - 20cm Length - 2.54mm - Set of 40 Set of 40 jumper wires with male connector at both ends. Allow you to..
₹57.82
Ex Gst ₹49.00
2 Pin Shunt - 2.54mm Pitch - Jumper Cap - Yellow ColorPackage Includes : 10x Yellow Jumper Cap 2.54mm
Position
2 Pin
..
₹29.50
Ex Gst ₹25.00
Duracell CR2032 3V Lithium Coin Cell BatteryThe Duracell CR2032 3V Lithium Coin Cell Battery is a reliable and widely used power source for various el..
₹40.00
Ex Gst ₹33.90
400 Tie Points - Solderless BreadboardHigh Quality breadboard with power lanes and printed top face for easy prototyping.Specifications..
₹57.82
Ex Gst ₹49.00₹588.82
All Inclusive, Shipping Calculated at Checkout
B2B GST Credit Available
- Stock: 0 in Stock
- SKU: 2271
- Delivery Time
- Bulk & B2B RFQ
ENC28J60 Ethernet Module - SPI Interface
The ENC28J60 Ethernet Module utilizes the Microchip ENC28J60 Stand-Alone Ethernet Controller IC featuring a host of features to handle most of the network protocol requirements. The board connects directly to most microcontrollers with a standard SPI interface with a transfer speed of up to 20MHz.
This Ethernet Breakout-Module is simplest way to add LAN connectivity to your microcontroller based products and projects. ENC28J60 implements PHY and MAC layer to enable network communication for Microcontrollers.
ENC28J60 Datasheet (Microchip)
- Fully Compatible with 10/100/1000Base-T Networks
- Integrated MAC and 10Base-T PHY
- Supports One 10Base-T Port with Automatic Polarity Detection and Correction
- Supports Full and Half-Duplex modes
- Automatic Programmable Retransmit on Collision
- Programmable Padding and CRC Generation
- Automatic Rejection of Erroneous Packets
- SPI Interface with Clock Speeds Up to 20 MHz
- Chipboard ENC28J60/SS.
- On board 25MHZ crystal.
- On Board MagJack RJ45 Connector HR911105A.
- Interface libraries available for variety of platforms such as Arduino, AVR, STM32 etc.
