Menu
Your Cart
Our order fulfillment operations will remain suspended on 29th and 30th March 2024 for FY Closing. Any order placed after 2 PM on 28th March will be shipped on 1st April 2024. 

NUCLEO-F411RE STM32F411RE, mbed-Enabled Development Nucleo-64 series ARM® Cortex®-M4 MCU 32-Bit Embedded Evaluation Board

NUCLEO-F411RE STM32F411RE, mbed-Enabled Development Nucleo-64 series ARM® Cortex®-M4 MCU 32-Bit Embedded Evaluation Board
ST Microelectronics
NUCLEO-F411RE STM32F411RE, mbed-Enabled Development Nucleo-64 series ARM® Cortex®-M4 MCU 32-Bit Embedded Evaluation Board
₹​2,063.82
₹​1,749.00 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 17
B2B GST Credit Available

Unleash your creativity by implementing new concepts with STM32 microcontroller series development board offering wide scope in developing and testing applications with on-board support of 72 MHz Cortex-M4 series microcontroller and flash memory of 512Kb. The particular board is a mainstream level board for testing large variety of development application with unique hardware and software features, integrating ST-Link debugger/programmer with separate selection-mode switch which enable the board to be used as a standalone ST-LINK/V2-1. The board also dual open platform support by integrating Arduino UNO V3 and ST morpho extensions, which opens wide scope for implementing specialised application work on Arduino platform and STM32 board. The STM32 development series board comes with comprehensive software HAL library provide extensive range of development environments including IAR EWARM, Keil MDK-ARM, mbed and GCC/LLVM-based IDEs and ARM mbed on-line resources for many automation and control integrated solutions.


Key Features:

  • STM32 microcontroller in QFP64 package
  • Two types of extension resources:
  • Arduino Uno V3 connectivity
  • ST morpho extension pin headers for full access to all STM32 I/Os
  • On-board ST-LINK/V2-1 debugger/programmer with SWD connector:
  • Selection-mode switch to use the kit as a standalone ST-LINK/V2-1
  • USB VBUS or external source(3.3V, 5V, 7 - 12V)
  • Power management access point
  • USB communication (LD1), user LED (LD2), power LED (LD3)
  • Flexible board power supply:
  • Virtual COM port
  • Mass storage
  • Debug port
  • Three LEDs:
  • Two push-buttons: USER and RESET
  • USB re-enumeration capability. Three different interfaces supported on USB:
  • Support of wide choice of Integrated Development Environments (IDEs) including IAR, ARM Keil, GCC-based IDEs


Resources

User Manual 

Write a review

Note: HTML is not translated!
Bad Good
Captcha