Menu
Your Cart
Our order fulfillment operations will remain suspended on 29th and 30th March 2024 for FY Closing. Any order placed after 2 PM on 28th March will be shipped on 1st April 2024. 

CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion

CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
WaveShare Electronics
CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion
₹​1,531.64
₹​1,298.00 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 13
B2B GST Credit Available
Price in reward points: 1298

CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion

This is a  CAN Bus Module for Raspberry Pi Pico, UART to CAN conversion. The Pico Can A Module Comes With Standard Raspberry Pi Pico header, supports Raspberry Pi Pico series.


User Maual / Datasheet / Example Codes Etc.


Features

  • Standard Raspberry Pi Pico header, supports Raspberry Pi Pico series.
  • Incorporates E810-TTL-CAN01 module, UART to CAN bus conversion.
  • Three conversion methods: transparent conversion, transparent conversion with identification, and protocol mode conversion.
  • Provide a complete supporting manual (example programs such as Raspberry Pi Pico C/C++ and MicroPython).


Specifications

  • Operating voltage: 3.3V
  • CAN transceiver: E810-TTL-CAN01
  • Communication bus: UART
  • Baudrate: 300~921,600 bps
  • Dimension: 58 × 25mm



Pinout Definition



What's On Board


  1. E810-TTL-CAN01 module
  2. Module operating indicator
  3. Module status indicator
    operating mode: blinking at 1Hz frequency
    command configuration mode: blinking at 5Hz frequency
  4. TX/RX indicators
  1. Resistor config
    ON: connected to 120R matching resistor
    OFF: disconnected from 120R matching resistor (default)
  2. CAN bus terminal
  3. Power supply selection
  4. UART selection


Dimensions



Write a review

Note: HTML is not translated!
Bad Good
Captcha