Menu
Your Cart
Our order fulfillment operations will remain suspended on 29th and 30th March 2024 for FY Closing. Any order placed after 2 PM on 28th March will be shipped on 1st April 2024. 

296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface

296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface
296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface
296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface
296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface
WaveShare Electronics
296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface
₹​1,991.84
₹​1,688.00 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 17
B2B GST Credit Available

296×128, 2.9inch flexible E-Ink display HAT (D) for Raspberry Pi, black/white dual-color, SPI interface

This is a flexible E-Ink display HAT for Raspberry Pi, 2.9inch, 296×128 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Compared with normal e-Paper panels, this flexible panel allows bending without being damaged, and it's thinner and lighter. Combined with the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications where curved surface display is required, such as industrial instruments, smart wearable-devices, and so on.


Package Consists:

  • → 2.9inch e-Paper (D) x1
  • → e-Paper Driver HAT x1
  • → RPi screws pack (2pcs) x1
  • → PH2.0 20cm 8Pin x1

Features:

  • → Flexible e-Paper, the display section is bendable (DON'T bend the FPC section)
  • → No backlight, keeps displaying last content for a long time even when power down
  • → Ultra low power consumption, basically power is only required for refreshing
  • → Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
  • → Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
  • → Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Technical Specifications:

  • → Operating voltage: 3.3V
  • → Interface: 3-wire SPI, 4-wire SPI
  • → Outline dimension: 79mm × 36.7mm × 0.34mm
  • → Display size: 66.9mm × 29.06mm
  • → Dot pitch: 0.227 × 0.226
  • → Resolution: 296 × 128
  • → Display color: black, white
  • → Grey level: 2
  • → Full refresh time: 2s
  • → Refresh power: 26.4mW(typ.)
  • → Standby power: <0.017mW
  • → Viewing angle: >170°

Resources:

www.waveshare.com/wiki/2.9inch_e-Paper_HAT_(D)




2.9inch e-Paper HAT (D) dimensions

 

Write a review

Note: HTML is not translated!
Bad Good
Captcha