New
WIZNET
₹1,100.00 + 18% GST
B2B GST Credit Available
WIZnet W5500-EVB-Pico2 RP2350 & W5500 Based Evaluation Board
₹1,298.00
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 11
B2B GST Credit Available
Price in reward points: 1100
- Stock: 0 in Stock
- SKU: 06402
- Delivery Time
- Bulk & B2B RFQ
WIZnet W5500-EVB-Pico2 RP2350 & W5500 Based Evaluation Board
W5500-EVB-Pico2 is a microcontroller evaluation board based on the Raspberry Pi RP2350 and the fully hardwired TCP/IP controller W5500 enhancing the capabilities of the traditional Raspberry Pi Pico2 board with additional Ethernet functionality via W5500.
- Raspberry Pi Pico2 Clone
- Ethernet (W5500 Hardwired TCP/IP CHIP)
Resource
Features
- RP2350 Microcontroller with Integrated 16Mbit Flash
- Symmetric dual Arm Cortex-M33 cores at up to 150MHz
- 520kByte multi-bank high performance SRAM
- External Quad-SPI Flash with eXecute In Place (XIP) capabilities
- Enhanced performance full-crossbar bus fabric
- Up to 48 multi-function General Purpose IO (8 can be used for ADC on RP2350-B)
- 1.8-5.0V IO Voltage
- Security Features
- One Time Programmable (OTP) Memory: Used for boot configuration and secure key storage.
- Secure Boot: Ensures that only authenticated software can run on the device, utilizing OTP for key verification.
- Arm TrustZone Technology: Provides hardware isolation between secure and non-secure software, enhancing security for critical applications.
- Analog and Digital Peripherals
- 12-bit 500ksps Analogue to Digital Converter (ADC)
- 2 × UART, 2 × I2C, 2 × SPI, 16 × PWM channels
- 1 × Timer with 4 alarms, 1 × Real Time Counter
- 3 × Programmable IO (PIO) blocks, 12 state machines total
- Flexible, user-programmable high-speed IO
- Can emulate interfaces such as SD Card and VGA
- W5500 Ethernet Controller
- Supports Hardwired Internet Protocols: TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
- Supports 8 Independent Hardware SOCKETs simultaneously
- Internal 32 Kbytes Memory for TX/ RX Buffers
- Supports High Speed Serial Peripheral Interface (SPI MODE 0, 3)
- Connectivity
- C-Type USB port for power and data (and for reprogramming the Flash)
- 40 pin 21x51 'DIP' style 1mm thick PCB with 0.1" through-hole pins also with edge castellations
- 3-pin ARM Serial Wire Debug (SWD) port
- Networking
- 10 / 100 Ethernet PHY embedded
- Supports Auto Negotiation
- Full / Half Duplex
- 10 / 100 Based
- Built-in RJ45
- Power Supply: Built-in Switch-mode DC-DC converter (replacing LDO for enhanced power efficiency)
Pin-out
