SIM7600G-H 4G / 3G / 2G / GNSS Module for Jetson Nano, LTE CAT4, Global Applicable

This is a 4G/3G/2G communication and GNSS positioning module designed for Jetson Nano, it supports global LTE CAT4 up to 150Mbps for downlink data transfer, with pretty low power consumption.

Just attach it onto the Jetson Nano Developer Kit, easily enable functions like 4G high speed connection, wireless communication, remote video monitoring, making telephone call, sending SMS, global positioning, and so on.

Features

• 40PIN GPIO extension header for connecting Jetson Nano
• Supports dial-up, telephone call, SMS, mail, TCP, UDP, DTMF, HTTP, FTP, etc.
• Supports GPS, BeiDou, Glonass, LBS base station positioning
• Onboard USB interface, to test AT Commands, get GPS positioning data, and so on
• Breakout UART control pins, to connect with host boards like Arduino/STM32
• SIM card slot, supports 1.8V/3V SIM card
• Onboard 3.5mm audio jack with earphone and mic support, for making telephone call
• 2x LED indicators, easy to monitor the working status
• Onboard voltage translator, operating voltage can be configured to 3.3V or 5V via jumper
• Baudrate: 300bps ~ 4Mbps (default: 115200bps)
• Autobauding baudrate: 9600bps ~ 115200bps
• Control via AT commands (3GPP TS 27.007, 27.005, and V.25TER command set)
• Supports SIM application toolkit: SAT Class 3, GSM 11.14 Release 99, USAT
• Comes with development resources and manual (examples for Jetson Nano/Raspberry Pi/Arduino/STM32)

Resources

User Manual

Onboard Peripherals

1. SIM7600G-H
2. NAU8810 audio decoder
3. TXS0108EPWR voltage translator: translates 3.3V/5V into 1.8V
4. MP1482 power chip
5. RT9193-33 voltage translator: translates 5V into 3.3V
6. 40PIN GPIO header: for connecting with Jetson Nano Developer Kit
7. SIM card slot: supports 1.8V/3V SIM card
8. USB interface: for testing AT Commands, getting GPS positioning data, etc.
9. 3.5mm earphone/mic jack
10. MAIN antenna connector
11. AUX antenna connector
12. GNSS antenna connector
13. Network status indicator
14. Power indicator
15. UART enable switch:
    ON: connect UART ports of SIM7600 and Jetson Nano
    OFF: disconnect UART ports of SIM7600 and Jetson Nano
16. Operating voltage selection jumper:
    VCC - 3.3V: set operating voltage as 3.3V
    VCC - 5V: set operating voltage as 5V
17. PWR control config:
    PWR - 5V: SIM7600 auto startup on power up
    PWR - D6: SIM7600 will be turned on/off by D6 pin of Jetson Nano