Menu
Your Cart

Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera

Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
WaveShare Electronics
Nano Base Board (C) for Raspberry Pi Compute Module 4, Same Size as the CM4, Onboard 8MP Camera
₹​2,535.82
₹​2,149.00 + 18% GST
All Inclusive, Shipping Calculated at Checkout
Assured Cashback of ₹ 21
B2B GST Credit Available

CM4-NANO-C (Raspberry Pi CM4 Ultra Mini Expansion Board Type B) is a baseboard that can be used with Raspberry Pi Compute Module 4. Although it is tiny, it can bring out the interface of Raspberry Pi Compute Module 4 with an onboard camera.


Resources

User Manual


Specifications

CM4 SOCKETsuitable for all variants of Compute Module 4
CONNECTORRaspberry Pi 40PIN GPIO header × 1
USBUSB 2.0 Type A port × 1
DISPLAYMIPI DSI port × 1 (15pin 1.0mm FPC connector)
CAMERAIMX219-D160 (8MP, 160°FOV)
VIDEOMini HDMI port × 1, supports 4K 30fps output
STORAGETF card socket for Compute Module 4 Lite (without eMMC) variants
POWER INPUT5V
DIMENSIONS55.0 × 40.0mm


Onboard Peripherals


  1. CM4 socket
    suitable for all variants of Compute Module 4
  2. Mini HDMI port
    supports 4K 30fps output
  3. DSI port
    MIPI DSI display interface
  4. USB2.0 port
    for connecting sorts of USB devices
  5. TF card slot
    for connecting a TF card with pre-burnt image (Lite variant ONLY)
  6. Power supply / Programming
    5V power supply, or used for eMMC burning
  7. 40PIN GPIO header
    for connecting sorts of HATs
  1. IMX219-D160 Camera
    8MP, 160° FOV
  2. User button
    Connect to GPIO21
  3. BOOT switch
    ON: Switch USB to Type C interface, will enter download mode when powered on (configured as a large-capacity disk through RPI boot)
    OFF: Switch USB to Type A interface, will not enter download mode when powered on (booted from eMMC or TF card)
  4. ACK Indicator
    CM4 working status
  5. PWR Indicator
    CM4 power status

Write a review

Note: HTML is not translated!
Bad Good
Captcha